Digital Water BathS
SWB6D, SWB15D and SWB24D
Instructions for use
introduction
Thank you for purchasing this piece of Stuart
equipment. To get the best performance from the
equipment and for your own safety, please read
these instructions carefully before use. Before
discarding the packaging check that all parts are
present and correct.
This e by Stuart, the protection provided may be
impaired.
electrical installation
thiS eQUiPMeNt MUSt Be eartheD
Before connection please ensure that the line
supply corresponds to that shown on the rating
plate.
Model
Supply requirements
SWB6D
230V, 50Hz
SWB15D
230V, 50Hz
SWB24D
230V, 50Hz
All models are supplied with two mains leads fitted
with IEC plugs for connection to the instrument.
One has a U.K. 3 pin plug and the other has a 2 pin
"Shuko" plug for connection to the mains. Choose
the lead appropriate for your electrical installation
and discard the other. Should neither lead be
suitable, take the lead with the U.K. plug and
replace the plug with a suitable alternative. This
involves cutting off the moulded plug, preparing the
cable and connecting to the re-wireable plug in
accordance with its instructions.
thiS OPeratiON ShOUlD ONlY Be
UNDertaKeN BY a QUaliFieD eleCtriCiaN
NOte: Refer to the equipment's rating plate to
ensure that the plug and fusing are suitable for the
voltage and wattage stated
The wires in the mains cable are coloured as follows:
BROWN
BLUE
Power
GREEN/YELLOW
500W
1000W
The instruments are fitted with an IEC socket at the
1700W
rear of the instrument for connection of the mains
lead. The appropriate mains lead should be
connected BeFOre connection to the mains supply.
Should the mains lead need replacement, a cable of
1mm
IEC320 plug should be used.
iF iN DOUBt CONSUlt a QUaliFieD
eleCtriCiaN
Safety advice Before Use
CaUtiON – Fuse fitted in both live and
neutral lines.
-
LIVE
-
NEUTRAL
-
EARTH
2
of harmonised code H05W-F connected to an
The unit should be carried with both hands,
with fingers under each side.
Never move or carry the unit when filled with
water, while it is in use or connected to the
mains supply.
Allow water to cool before draining.
1