Programmed Disc Play - Roadstar CLR-2981MP Manuel D'instructions

will begin from the start of the first track of the disc.
3. At the end of the disc, the unit will switch to stop mode and the play indicator will go out.
Notes: If the disc is deeply scratched, or too dirty, disc play may not start.
If an improperly centred disc is played, noise can be heard in the mechanism. The
use of such discs should be avoided.
IMPORTANT INFORMATION
This compact disc player has built-in error compensation circuits to correct for minor defects
in a disc. There are limits, however, to the amount of correction available.
In some cases the CD player may skip some tracks on a disc during disc play. This problem
may be caused by defects (such as scratches) on the disc being played, which are too large
for the error compensation circuits to handle.
TO STOP CD PLAY
4. Press the Stop Button (24). Disc play will stop, the Play indicator will go off, and the
display will show the total number of tracks on the CD.
5. To temporarily stop disc play (pause mode), press the Pause Button (23). Disc play will
stop at the current play position. The CD display will begin to flash.
6. To resume disc play, press the Play Button again.
Starting disc play from the beginning of a particular track
• Press the Forward or Reverse Skip Track Buttons (20/17) to select the desired track.
The number of the selected track will be shown on the CD display. Press the Play/
Pause Button (23) to start play.
To skip to the next track
1. Press the Skip Forward (20) Button once to skip to the beginning of next track.
Continuously pressing the Forward Skip Track Button until the desired trade is reached.
Once the beginning of the last track is reached the CD player will not advance any
further.
To skip back to the previous track on a disc
1. To skip back to the beginning of current track. Press the skip Backward (17) once.
2 To skip back to the beginning of previous track.
Press the skip Backward (17) Skip Track Button twice.
Continuously pressing the Reverse (17) Skip Track Button makes the CD player skip
back through the disc track by track. Once the beginning of the first track is reached, the
CD player will not go back any further.
English 5 6 English
Manual Search
• During playback, pressing the Forward or Reverse Skip / Search buttons will cause the
player to scan through the current track. At the end of a track the player will skip to the
next track and continue scanning. At the beginning of a track the player will skip to the
previous track and continue scanning.
• When the player reaches the end of the final track, or the beginning of the first track, it will
stop scanning.

PROGRAMMED DISC PLAY

It is not possible to enter programs during disc play. Press the Stop button (24) first, then follow
the instructions below.
Press the Program button (18). The following information will be displayed on the CD
Display:
and the Program indicator will flash in the dispay.
Press the Forward and Reverse Skip Track buttons to select the track to be stored in
location "01" (i.e. track no. 3).
Press the Program Button (18). The first program selection is now stored in the program
memory and the following information will be displayed on the CD Display:
The Program indicator will flash in the display.
Select the next track to be programmed using the Forward and Reverse Skip Track
buttons.
Press the Program button (18) to store this track.
Continue entering tracks in this way until all the desired tracks are stored (up to a limit of 21).
If you wish to add a track to the program, press the Program button (2) until the last
programmed track is displayed. Press the Program button again. Press the Forward or
Reverse Skip Track buttons until the desired track is displayed, then press the Program
button. The added track will be entered as the last track in the program memory.
P 01
003
P 02