Ryobi CSB144LZ Manuel D'utilisation page 12

TO BEVEL CUT
See Figure 21, page 18.
 Hold the saw firmly with both hands as shown.
 Rest the front edge of the base on the workpiece.
 Start the saw and let the blade reach full speed.
 Guide the saw into the workpiece and make the cut.
 Release the switch and allow the blade to come to a
complete stop.
 Lift the saw from the workpiece.
POCKET CUTTING
See Figure 22, page 18.
WARNING:
Always adjust bevel setting to zero before making a
pocket cut. Attempting a pocket cut at any other setting
can result in loss of control of the saw possibly causing
serious injury.
 Adjust the bevel setting to zero and tighten the bevel lock
knob.
 Set the blade to the correct blade depth setting.
 Swing the lower blade guard up using the lower blade
guard handle.
NOTE: Always raise the lower blade guard with the handle
to avoid serious injury.
 Hold the lower blade guard by the handle while keeping
your hand on the front handle as shown.
 Rest the front of the base flat against the workpiece with
the rear of the handle raised so the blade does not touch
the workpiece.
 Start the saw and let the blade reach full speed.
 Guide the saw into the workpiece and make the cut.
OPERATION
WARNING:
Always cut in a forward direction when pocket cutting.
Cutting in the reverse direction could cause the saw to
climb up on the workpiece and back toward you.
 Release the switch and allow the blade to come to a
complete stop.
 Lift the saw from the workpiece.
 Clear corners out with a hand saw or sabre saw.
WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious injury.
OPTIONAL DUST NOZZLE KIT
See Figure 23, page 19.
You may purchase a dust nozzle kit, part no. 200673002,
for use with the saw. The adaptor fits over the dust chute
which is located on the upper blade guard. The nozzle at-
taches to the adaptor.
NOTE: If you use the nozzle, you should always connect it
to a standard vacuum hose.
To attach the dust nozzle:
 Unplug the saw.
 Lift lower blade guard.
 Orient adaptor to fit into the dust chute opening on upper
blade guard.
 Secure adaptor with screw provided.
 Align hole in nozzle with raised lip on adaptor and snap
into place when using a vacuum hose.
12 - English