Majolicas (If Present); Products Made Of Natural Stone (If Present); Varnished Products (If Present); Enamelled Products (If Present) - Nordica TERMOROSSELLA PLUS EVO DSA 4.0 Manuel Utilisateur

MAjOLICAs (IF PREsENT)

La NORDICA s.p.A.has chosen majolica tiles, which are the result of high-quality artisan work. as they are completely carried out by hand,
the majolica may present crackles, speckles, and shadings. These characteristics certify their precious origin.
enamel and majolica, due to their different coefficient of dilatation, produce microcrackles, which show their authentic feature.
foR THe CLeaninG of THe MaJoLiCa We sUGGesT yoU To Use a sofT and dRy CLoTH;
IF YOU UsE A DETERgENT OR LIqUID, THE LATTER MIgHT sOAk IN AND HIgHLIgHT THE CRACkLEs PERMANENTLY.

PRODUCTs MADE OF NATURAL sTONE (IF PREsENT)

naTURaL sTone Has To Be CLeaned WiTH VeRy THin aBRasiVe papeR oR WiTH an aBRasiVe sponGe. DO NOT UsE any CLeanseR
oR fLUid.

VARNIsHED PRODUCTs (IF PREsENT)

after some years of product use a change in the varnished details colour is totally normal. This is due to the considerable temperature range
the product is subject to whenever in use and to the varnish ageing of time passing by.
ATTENTION: BefoRe any possiBLe appLiCaTion of THe neW VaRnisH, do CLean and ReMoVe aLL THe TRaCes fRoM
THe sURfaCe WHiCH Has To Be VaRnisHed.

ENAMELLED PRODUCTs (IF PREsENT)

for the cleaning of enamelled surfaces use soap water or NOT AggREssIVE and NOT CHEMICALLY abrasive detergents.
afTeR THe CLeaninG DO NOT LeT soapy WaTeR oR any CLeanseR dRy BUT ReMoVe THeM iMMediaTeLy.
DO NOT UsE sANDPAPER OR sTEEL WOOL.

CHROMIUM-COMPONENTs (IF PREsENT)

if the components become bluish due to overheating, this can be solved with a suitable product for cleaning. DO NOT use abrasives or
solvents.

MAINTENANCE ON THE WATER sYsTEM

exCessiVe inCRUsTaTion deposiTs on THe inneR WaLLs of THe HeaRTH ConsideRaBLy RedUCe THe effiCienCy of
HeaT exCHanGe; THeRefoRe, ReMoVe THese deposiTs UsinG a sTeeL BRUsH WHeneVeR neCessaRy.
NEVER UsE CORROsIVE sUBsTANCEs THAT CAN DAMAgE THE THERMO-FIREPLACE AND THE BOILER.
WiTH THe sysTeM sWiTCHed off, onCe a yeaR CaRRy oUT THe foLLoWinG CHeCks:
Š Check the operation and efficiency of the blowdown and safety valves. if THey aRe defeCTiVe, ConTaCT yoUR aUTHoRised insTaLLeR.
IT Is sTRICTLY FORBIDDEN TO REMOVE OR TAMPER WITH THE sAFETY DEVICEs.
Š Check the thermal insulation of the filling pipe and the safety pipe.
Š Make sure that the system is filled and under pressure, checking the water level in the expansion tank; also check that it is working properly
and check the efficiency of the safety pipe.

sUMMER sTOP

after cleaning the hearth, chimney and hood, totally eliminating the ash and other eventual residues, close all the doors of the hearth and
the relevant registers; in case you disconnect the appliance from the chimney you must close its openings in order to let work others possible
appliances connected to the same flue.
We sUGGesT peRfoRMinG THe CLeaninG opeRaTion of THe fLUe aT LeasT onCe peR yeaR; VeRifyinG in THe MeanTiMe THe aCTUaL
sTaTUs of THe Rope seaLs, WHiCH CannoT ensURe THe Good opeRaTion of THe eQUipMenT if THey aRe noT in Good CondiTion
and aRe noT MakinG a Good seaL! in THis Case THe seaLs MUsT Be RepLaCed.
in pResenCe of daMpness in THe RooM WHeRe THe pRodUCT Has Been pLaCed, We adVise yoU To pUT aBsoRBenT saLTs inTo
THe HeaRTH.
if yoU WanT To keep foR LonG THe aesTHeTiC Look of THe CookeR iT is iMpoRTanT To pRoTeCT iTs inTeRnaL WaLLs
in RoW CasT iRon WiTH neUTRaL VaseLine.
CHECk THE WATER LEVEL IN THE ExPANsION TANk and ReMoVe any aiR fRoM THe sysTeM By BLeedinG THe RadiaToRs; aLso
CHeCk To Make sURe THaT THe pLUMBinG and eLeCTRiCaL aCCessoRies (ConTRoL UniT, CiRCULaToR) aRe WoRkinG pRopeRLy.
ATTENTION: foR no Reason MUsT THe fiRe Be iGniTed BefoRe THe sysTeM Has Been CoMpLeTeLy fiLLed WiTH WaTeR;
doinG THis WoULd Lead To seRioUs daMaGe of THe enTiRe sTRUCTURe. THe insTaLLaTion MUsT aLWays Be fULL of
WaTeR eVen WHen THe appLianCe is noT Used.
ENGLISH 41