Maintenance And Cleaning Operations; Steam Tube Cleaning - La Pavoni EUROPICCOLA Mode D'emploi

English
hot parts such as the boiler (9), the unit (11) and the filter-holder (10), to avoid burns and possible scalds.
Do not remove the filter-holder and do not absolutely put your hands under the unit
during the delivery, to avoid possible scalds.
Do not open the boiler cap (3) when the machine is working or still under pressure,
to avoid possible burns.
FIG 3
Torx type screw, to avoid tampering with electrical parts; therefore, for any type of
intervention and in case of replacement of the power supply cable, please refer to the
authorised SERVICE CENTRES.
14 – MAINTENANCE AND CLEANING OPERATIONS
Before conducting any kind of cleaning operation, unplug the main cable from the power socket without
pulling the cable.
Clean regularly the filter holder (10), the filter basket (16), and the perforated filter plate placed under
the group (11) to avoid incrustations, and keep dry the drip tray (8) and the drain well on the base to
avoid water infiltration inside the base.
14.1 – STEAM TUBE CLEANING
To avoid altering the taste of the drinks to be heated and the clogging of the holes of the steam pipe
ending, clean carefully the steam pipe after every use.
14.2 - CLEANING OF THE AUTOMATIC CAPPUCCINO MAKER
Apart from cleaning it every time it has been used, please clean it every now and again more accurately
(picture 3):
• Unscrew the threaded nut (A) turning it anticlockwise until the steam nozzle comes out.
• Remove the cover ( D), the pin ( C ), and the pipe ( B ), wash then all in fresh water. Rinse everything
thoroughly with warm water to remove possible milk rests and reassemble the Automatic Cappuccino
maker again.
To screw the cap off and refill the boiler, place the switch (6) on
the OFF position, slowly turn the steam tap knob (4) anticlockwise
to open it, and wait for all the steam contained in the boiler to be
discharged by the pipe provided (12); in case the steam does not
come out properly, remove the filter-holder (10) and slowly lift the
lever (1); hold the lever up to allow the steam and water contained
in the boiler to be discharged through the unit.
In both cases, it is advisable to use a container for steam and water
collection, paying attention since the steam and water discharged
are overheated and may cause scalds. When the steam and water
stop discharging, unscrew the boiler cap slowly.
When the machine is off, during the process of cooling down,
it may happen that the lever moves upward by itself. This
phenomenon is caused by the depression forming inside the boiler
itself.
If the machine is not used often, switch it off, placing the ON/OFF
switch on the OFF position and removing the main cable plug from
the socket without pulling it.
The base-mat is fixed to the machine with a special
40