Pelgrim RSK860 Mode D'emploi page 70

USE
Controls
GB 10
L5
L4
L3
L2
L1
Switching on the grease saturation indicator for the activated
carbon filter
Switch off the extractor hood and press and hold the
(4) buttons simultaneously for 3 seconds.
The L1 and L2 indicators will start to flash for 5 seconds.
Switching off the grease saturation indicator for the activated
carbon filter
Switch off the extractor hood and press and hold the
(4) buttons simultaneously for 3 seconds.
The L1 indicator will start to flash for 2 seconds.
Thermal cut-out
The hood is supplied with a temperature sensor that switches the motor
to speed 3 if the temperature near the controls becomes too hot.
This is indicated by the L1, L2, L3 indicators that start flashing.
This situation will continue until the temperature has dropped to a safe
level. To exit this mode press the
4
3
5
2
1
(1) and
(1) and
(1) or (2) key.