Pelgrim RSK860 Mode D'emploi page 69

USE
Controls
L5
L4
L3
L2
L1
Grease saturation indicator for grease filter
After 40 operating hours the L5 indicator switches on. When the
indicator lights up, the grease filter that has been installed must be
cleaned.
To reset the indicator, press and hold the
Grease saturation indicator for activated carbon filter
After 160 operating hours the L5 indicator will start flashing.
When the indicator lights up, the activated carbon filter that has been
installed must be replaced.
To reset the indicator, press and hold the
In the event that the grease saturation indicator refers to both filters:
The L5 indicator will switch on for 3 seconds and then flash 3 times.
To reset, follow the instructions above twice.
The first time the grease filter indicator is reset, the second time the
active carbon filter is reset.
In default mode the active carbon filter indicator will not switch on.
If the extractor hood is used in recirculating mode, then the activated
carbon filter indicator must be switched on.
4
3
5
2
1
(1) button for 3 seconds.
(1) button for 3 seconds.
GB 9