emerio FN-111745.3 Mode D'emploi page 5

FN-111745.3 / FN-111745.4
PARTS DESCRIPTION
1. Front guard
2. Guard securing clip
3. Blade fastening screw
4. Blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Shaft pin
9. Oscillation knob
10. Speed control buttons
11. Bulge
12. Space
13. Standing shaft
14. Standing base
15. Power cord
ASSEMBLING INSTRUCTIONS
1. Base Assembly
Put power cord (15) through the hole of standing base (14), and make the bulge (11) on standing shaft (13) align
with the space (12) of base hole, turning the standing shaft clockwise to fix it onto the standing base.
2. The Whole Assembly
Remove the blade fastening screw (3) and guard fastening screw (5) from the motor shaft (7) spindle.

Fit the rear guard (6) by positioning with the location pins. Secure the guard onto the motor body with the

guard fastening screw (5).
Place the fan blade (4) onto the motor shaft by matching the slot with the shaft pin (8). Fix the blade by

tightening the blade fastening screw (3) in a counter-clockwise direction. Check that the fan blade can rotate
freely by turning it with your hand.
Position the top clip of front guard (1) onto the uppermost part of the rear guard (6). Press the rim of front

guard onto the rear guard. Close the bottom clip.
OPERATING INSTRUCTIONS
1. Plug the power cord into a suitable socket.
2. Oscillation: To make the fan head oscillate, push down the oscillation knob (9). To stop the fan head from
oscillating, pull up the oscillation knob.
3. The fan is switched on and off by pressing the speed control buttons, i.e. 0 = Off, 1 = Low air flow peed, 2 =
Medium air flow speed, 3 = High air flow speed.
Tilting Angles: By pushing the fan-guard, you can adjust the fan to the preferred elevation.
4.
CAUTION: Press only one of the speed control buttons at a time. Permanent damage to the switch housing may
result if two or more of the buttons are pressed simultaneously.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
- 4 -
EN