Operating The Single Radiant Surface Elements - KENMORE ELITE 790.4531 Série Manuel D'utilisation Et D'entretien

Setting Surface Controls (cont'd)
Operating Single Radiant Surface Elements
The cooktop has 4 SINGLE radiant surface elements: the RIGHT REAR, LEFT REAR, CENTER REAR and the LEFT FRONT
positions (Fig. 1 & 2).
To Operate the Single Radiant Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
Note: If no key pad is touched within 10 seconds the request to Power ON the cooktop will
clear.
3. Touch the pad for the desired element position until a beep is heard. The display will
show "--". Note: If no further pads are touched within 10 seconds the request to power the
element ON will clear.
4. Touch pad once to turn ON the power level to HI (See Fig. 3). Touch
once for Lo.
5. Each touch of the
9.5 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2 will
decrease or increase by .2 increments. Lo is the lowest power level available. Note:
The power level may be adjusted at any time while the element is ON.
6. Start most cooking operations on a higher setting and then turn to a lower setting
to fi nish cooking. Each surface element provides a constant amount of heat at
each setting. A glowing red surface heating area extending beyond the bottom
edge of the cookware indicates the cookware is too small for the surface heating
area.
7. When cooking has been completed touch the
OFF and if no other surface element is used touch the
cooktop.
Note: The HE (hot element) message will remain ON if the cooktop is still hot and
will remain ON until the heating surface area has cooled suffi ciently.
Radiant surface elements may appear to have cooled after they have been turned off . The glass surface may
still be hot and burns may occur if the glass surface is touched before it has cooled suffi ciently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the
range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fi re if placed too
close to the surface elements.
Do not allow aluminum foil, or ANY material that can melt to make contact with the ceramic glass
cooktop. If these items melt on the cooktop they will damage the ceramic cooktop.
key pad until a beep sounds. The power indicator light will turn ON.
or pad will decrease or increase the power level from
pad
pad once to turn the element
key pad to turn off the
10
Fig. 1 - 30" Model
Fig. 2 - 36" Model
Fig. 3