NEC MultiSync LCD1990SXp Manuel D'utilisation page 28

Advanced OSM Controls
Tag C SCHEDULE
continued continued
Tag D ECO MODE
INFORMATION
Tag E INFORMATION
To select which schedule to set, use the up/down arrows to
move the cursor vertically to select a schedule (1 to 7) to be set.
Use the "down" or "up" buttons to move the red bar horizontal-
ly within the particular schedule. The "SELECT" button is used to
make a selection . If you create a schedule but do not want to
use a power on time, select "--" in the "ON" time slot. If you do
not want to use a power off time select "--" in the OFF time slot.
If there is no input selected ("-----" showing in the input spot) the
input from the previous schedule will be used. Selecting
EVERY DAY within a schedule takes priority over other sched-
ules that are set up to operate weekly.
Schedules are numbered 1-7. If two schedules are programmed
for the same time, then the highest numbered schedule has pri-
ority. For example schedule #7 will take priority over schedule
#5. When schedules are overlapping, a scheduled Power ON
time has priority over a scheduled Power OFF time.
When the "OFF TIMER" (see page 21) is set, the "SCHEDULE"
function is disabled.
Before powering off, a message will appear on the screen ask-
ing the user if they want to delay the turn off time by 60 minutes.
Press any OSM button to delay the turn off time.
Displays the estimated power saving information in watt-hours.
Provides information about the current display resolution as well
as technical data, including the preset timing currently being
used. Horizontal and vertical frequencies are also displayed.
26
- continued