NEC MultiSync LCD1990SXp Manuel D'utilisation page 21

Advanced OSM Controls
Tag 4 AUTO FINE
continued (Analog input only)
H. RESOLUTION
V. RESOLUTION
EXPANSION
H.ZOOM
Available in Custom
Expansion mode only
V.ZOOM
Available in Custom
Expansion mode only
ZOOM POS.
Available in Custom
Expansion mode only
This function automatically and periodically adjusts the "FINE"
setting for when there is a change in the input signal.
Adjustment occurs approximately every 33 minutes or when a
change in signal timing is detected.
Adjusts the Horizontal resolution.
Press "Left" or "Right" to adjust.
Adjusts the Vertical resolution.
Press "Left" or "Right" to adjust.
Selects the zoom mode.
FULL: The image expands to 1280 x 1024, regardless of the
resolution.
ASPECT: The image expands without changing the aspect ratio.
OFF: The image is not expanded.
CUSTOM: When CUSTOM is selected as the Expansion mode,
it becomes possible to adjust the H. ZOOM., V. ZOOM, and
ZOOM POS.
The image is expanded from 1 to 3 times in the horizontal
(H. EXPANSION) direction by 0.01 increments.
The image is expanded from 1 to 3 times in the vertical
(V. EXPANSION) direction by 0.01 increments.
Sets the point from which the screen will be expanded when ei-
ther H.ZOOM or V.ZOOM is selected as the expansion method.
Options are CENTER and LEFT TOP.
CENTER: H.ZOOM expands the image from the center outward
to the sides of the screen.
V.ZOOM expands the image from the center towards the top
and bottom of the screen.
LEFTTOP: LEFTTOP indicates the set point for image expansion
(LEFT in H.ZOOM, TOP in V. ZOOM). If the resolution does not
fi ll out the screen, when expanding, the image will not expand
past the TOP or the LEFT of the screen. The image can be
expanded past the right and bottom edges of the screen.
19
- continued