Publicité
Les langues disponibles
Les langues disponibles
the machine stated on the motor.
NOTE: Your mitre saw's electrical system
is equipped with an undervoltage relay
which automatically opens the circuit when
the voltage falls below a minimum pre-
established limit and prevents the self-reset
of machine functions when voltage returns
to normal levels.
If the machine stops involuntarily, do not be
alarmed.
Make sure that there has not been a
voltage failure in the electrical system.
ADJUSTMENTS
ATTENTION: All the adjustment procedures
illustrated below must be performed when
the machine's engine is off.
Rotary table 0°- 45° (Fig. 8).
By turning the table, the mitre saw can be
moved to the left- and right- hand side. The
rotary table can be quickly and precisely
set. For swinging the table, loosen the
locking knob (16) by approx. 2 turns and
move the table by table adjust lever (15) to
the desired angle. Then lock the table with
the locking knob (16).
Tilting the Saw Unit (Fig. 3)
The saw unit can be tilted up to an angle of
45º.
Loosen the locking screw (17) on the back
of the machine and, using the scale, tilt the
unit to the desired angular position.
The angle can be determined using the
indicator (20) on the scale (19). Finally, the
locking screw (17) must be securely re-
tightened.
Cutting length adjustment (Fig. 11)
For cutting widths up to approx. 100 mm
it is possible to fix the saw's drag function
with the locking screw for drag guide (18)
in rear position. If the cutting width exceeds
100 mm you must ensure that the locking
screw for drag guide (18) is slackened and
that the motor (6) can be moved.
Operations
After having performed all the above
procedures and operations, you may begin
cutting.
Warning: Always keep hands away from
the cutting area and do not try to approach
it when the machine is running.
Cross-cutting Operation (Fig. 4)
• Release the locking button (13)
• Raise the saw unit using the handle
(1) until the unit locks into the uppermost
position.
• Press the work piece uniformly against
your left side, while ensuring that your hand
is outside the cutting zone of the saw blade.
• Place the right hand on the handle (1), so
that the unit can be swiveled downward.
• After pressing of the start switch (2) the
engine starts running.
• Apply the saw blade slowly to the work
piece and cut through it by applying slight
pressure.
• Swing the unit back into the starting
position until it locks into place.
• Release the handle (1), so that the motor
shuts off.
Changing the Saw Blade (Fig. 5)
• Turn the saw off and unplug it from its
power source.
• Put saw head unit in the upper position.
• Release the movable saw blade guard (10)
and lifting the saw blade guard at the same
time to free the saw blade. Release the
screw (a) and lift the guard cover (21)
• Release the saw blade fixing screw
(Attention: left-handed thread).
• Take off the saw blade with caution (risk of
injury through saw blade teeth).
• Place the new saw blade onto the inner
saw blade flange, observing the turning
11
Publicité
