Matrix M1YL-LZ-210 Guide De L'utilisateur page 10

Assembly
WARNING! For your own safety, only
insert the mains plug in a socket after
you have completed all assembly steps,
and read and understood the safety and
operating instructions.
Take the saw out of its packaging and
position it on the work bench.
Remove the saw from the packaging and
place it on a workbench. (Positioning of
the saw on the workbench - see next page
under "POSITIONING / WORKSPACE")
Assembling the Saw Dust Bag
• Press the flaps of the metal ring together
and attach it to the discharge opening in the
engine area.
Appropriate Usage
Intended Usage
The machine cuts:
• Wood and wood-like materials
• Plastic
Inappropriate Usage
The machine is not suitable for:
• Ferrous materials, steel and cast iron, as
well as all other types of materials that are
not listed, especially food.
• Compound cuts without protection.
• Materials which are larger than the
indicated cutting capacities:
0°x0° 8 1/4 X 2 3/8 IN (210X60 mm)
45°x0° 5 11/16 X 2 3/8 IN (145X60 mm)
0°x45° 8 1/4 X1 11/32 IN (210X34 mm)
45°x45° 5 11/16 X 1 11/32 IN (145X34 mm)
Start-up
Observe the safety notes in the
operating instructions before operating
the machine.
REMOVAL OF PACKAGING
Remove the box used to protect the
machine during transportation and keep it
intact for future transportation and storage.
TRANSPORT
In case the machine needs to be
transported put it in the original packaging
in which it was delivered. See to it that
it is placed in the correct position (follow
signs on box).
If possible secure the box with straps to
avoid unintended movement or loss of parts
of the machine.
POSITION/WORK STATION
Place the machine on a work bench or on a
sufficiently flat base/pedestal to ensure the
best possible stability.
Bearing in mind ergonomic criteria, the
ideal height of the bench or of the base
should be such that the base surface or the
upper work surface is between 90 and 95
cm. from the ground.
Always ensure that there is at least 80
cm. of manoeuvring space in all directions
around the machine in order to perform
all necessary cleaning, maintenance
and adjustment operations safely with
a sufficient amount of space available.
WARNING: Ensure the machine is placed
in a suitable position both in terms of
ambient conditions and lighting. Always
bear in mind that overall ambient conditions
are of fundamental importance to prevent
accidents.
ELECTRICAL CONNECTIONS
Check that the electrical system to which
the machine is connected is grounded in
compliance with voltage safety regulations
and that the socket is in perfect condition.
The electrical system must be fitted with a
GFCI device to safeguard all conductors
from short circuits and overload.
The selection of this device should be in line
with the following electrical specifications of
10