Megger TPT420 Mode D'emploi page 5

TPT420 Feature
GS38
UK tip
Hand
barrier
Remote
probe
Operating instructions
Auto-power-on / switching on
The tester switches on when it detects continuity,
an AC or DC voltage above approx. 10 V or a
live phase on L2 (single pole test). It can also be
switched on with the torch light button.
Auto-power off
The tester is automatically powered off after
5 sec when there is no signal detected by the
probes. The torch light switches off after approx.
10 sec.
1.2 metre probe lead
5
Euro tip
LED torch
Display
Hand
barrier
Torch
button
Battery
cap