VINCENT PHO-701 Manuel D'utilisation page 31

Adjustments for MC systems
Input impedance: 1000 ohms
Input capcitance: 15 pF
The permanent input resistor cannot be deactivated. The input impedancecan be adjusted by using swit-
ches 3 to 6 (adjustment units 7)). All matching resistors are connected in parallel, therefore allowing
impedance values between 99 ohms (all resistors used) and 1000 ohms (no additional resistors used).
This is how you can find the best settings:
First listen to your favorite record using the highest impedance, then the lowest, and finally select a resistor
with a value of about 600 ohms. Now try different adjustments until you get the results you want.
All values can be found in the table below.
Keep in mind to set both channels to the same value!
Table of values (impedance)
Position „ON" Impedanz
keiner 1000 Ohm
6 783 Ohm
5 600 Ohm
5+6 514 Ohm
4 405 Ohm
4+6 364 Ohm
4+5 319 Ohm
4+5+6 293 Ohm
CONFIGURATION
Position „ON"
3
3+6
3+5
3+5+6
3+4
3+4+5
3+4+5+6
Impedanz
130 Ohm
126 Ohm
120 Ohm
116 Ohm
109 Ohm
102 Ohm
99 Ohm
Vincent
31