VINCENT PHO-701 Manuel D'utilisation page 25

8. OUT: signal output to the amplifier
A pair of RCA input sockets of your system's
audio amplifier must be connected with these
output sockets.
9. GND: Ground clamp for the
record player
In addition to the stereo signal connection
cable most record players are equipped with
a grounding cable that can be recognized by
the cable lug at the end of the cable. This lug
has to be fitted to the clamp "GND".
10. DC IN: power supply input of
the PHO-701
Make a connection to the power supply output
(4) of the PHO-701ps using the supplied DIN
cable.
REAR VIEW
12
11. MC/MM: pickup type switch
At this switch the type of record player pickup
system has to be selected to adapt the phono pre-
amplifier PHO-701 to that system. See section
"Setting the type of pickup system".
12. IN: signal input (MC/MM) from
the record player
The audio output (or as well an attached
audio cable) of the record player must be con-
nected to these input sockets
13. Fine adjustment mechanism (Bottom)
for MM/MC cartridges (more information on
page 29)
9 8
11
13
10
Vincent
25