Silk-n Jewel Mode D'emploi page 21

3. Set the energy level. Press the control button (#3)
repeatedly to increase the energy level until you have the
level you want. The energy level indicator lights (#2) indicate
the energy level setting (see section 4.6 Energy levels).
The number of energy level indicator lights (#2) that are on
indicates the energy level selected.
4. Decide if you wish to treat the area by Pulsing or Gliding
(refer to section 4.8 Pulsing and gliding).
5. Apply the treatment surface (#6) to the skin. Make sure
that the skin is spread evenly and smoothly. When the
treatment surface (#6) is in full contact with the skin, the
ready light (#4) will start blinking slowly.
6. The device will first determine the colour of your skin
automatically and it will flash a pulse of light onto your skin.
You will feel a mild sensation of warmth and tingling, and
you may hear a popping sound.
7. If you are pulsing, remove the device from your skin. The
device will immediately recharge for the next pulse. After
a few seconds (depending on the energy level) the ready
light (#4) will turn on again, and start blinking slowly when
pressed against the skin.
8. If you are pulsing, repeat the process. If you are gliding,
simply continue. Continue to pulse or glide until you have
treated the area fully.
Z
Avoid gaps or overlaps.
Z
The device will only emit repeated pulses when it is in firm
contact with your skin, and you keep moving it across your
skin.
[
Stop use immediately, if your skin blisters or burns, if you
feel very uncomfortable, or if the device gets too hot.
19
EN