Steba VG 350 BIG Mode D'emploi page 11

∙ The appliance must not be operated using a timer or a separate
remote system!
∙ Important: Never immerse the thermostat element or the po-
wer cord into water!
∙ Only use the device for food preparation
∙ Never use the device after a malfunction, e.g. when it was fal-
len down or was damaged in any way.
∙ To avoid any dangers must repairs, e.g. change of a defect po-
wer cord, only be done by our service or an authorised compa-
ny.
∙ Device gets hot. Only transport after it cooled down.
∙ If the appliance is used as a table top, it must be placed on a
even, stable and heat resisting surface (e.g. Not on painted fur-
niture) and keep away (min 70cm) of burnable materials (e.g.
curtains)
∙ Before the first use: Clean all parts and dry them afterwards. To
eliminate the smell of the new item, heat it up for ca. 15min.
The device can smoke a little bit at the beginning.
Attention! Housing get hot, Risk of burns! Don´t place
∙
the device on a sensitive surface (e.g. painted furniture)
and keep distance of at least 70 cm to burnable materi-
als (e.g. curtains).
∙ The appliance should be supplied through a residual current
device (RCD) having a rated residual operating current not ex-
ceeding 30mA.
∙ The connector shall be removed before the appliance is cleaned
and that the appliance inlet must be dried before the appliance
is used again.
11