Table des Matières
Publicité
SAFETY INSTRUCTIONS
12. Never attempt to open the enclosure of the control unit
or the power supply unit. Unauthorised opening of the
enclosure and improper repairs can cause danger and
voids the warranty.
13. Only professionals authorised by the manufacturer may
carry out any maintenance or reparations.
14. Do not operate devices in explosive environments.
15. This furniture is only certified for commercial office
and administrative areas within rooms.
16. The manufacturer assumes no liability for damage
resulting from improper use.
17. Connection plug boards must be fixed properly for easy
plugging and unplugging. Plugs and connection plug
boards must be located in such a way that no fluids
come into contact with electrical equipment when the
office furniture is used properly.
18. The power cable must be secured in the strain relief.
Interconnecting cables may be run loosely. All lines and
cables must be run in such a manner as to avoid
mechanical damage (i.e., shearing, abrasion,...).
19. If the furniture has movable or height-adjustable parts,
then particular care must be taken:
Cables must be sufficiently long to allow height
adjustments without damaging the cables and wiring
(i.e., stretching, crushing, ...).
20. If the electrical cable of this device is damaged, it must
be replaced by the manufacturer or by its customer
service or by a similarly qualified person to avoid risks.
21. Do not spill liquids into control unit or power supply unit
to avoid electrical shock or short circuits.
22. The operation of the control mechanism and the power
supply unit requires a minimum of 5°C and a maximum
temperature of 40°C.
23. For the above reasons do not use the control unit:
above or below heat sources ( e.g. heaters), at places
exposed to direct sunlight, in small, unventilated or
humid rooms, near easily flammable materials or near
high-frequency devices (e. g. transmitters, radiation
equipment or similar).
8
Publicité
Table des Matières
