RedMax GZ400 Mode D'emploi page 8

Table des Matières

Publicité

8
(a)
(b)
(c)
(d)
(e)
(f)
English
4. Symbols on the machine
For safe operation and maintenance,
symbols are carved in relief on the
machine.
According to these indications, please
be careful not to make any mistake.
(a) The port to refuel "MIX GASOLINE"
Position: Fuel cap
(b) The port to top up chain oil
Position: Oil cap
(c) By setting the switch to the "O" position, the engine
stops immediately.
Position: Rear-left of the unit
(d) If you pull out the choke knob (at the back-right of
the rear handle) to the point of the arrow, you can
set the starting mode as follows:
• HALF CHOKE position – starting mode when the
engine is warm.
• FULL CHOKE position – starting mode when the
engine is cold.
Position: Upper-right of the aircleaner cover
(e) The screw under the "H" stamp is the High-speed
adjustment screw.
The screw under the "L" stamp is the Slow-speed
adjustment screw.
The screw at the left of the "T" stamp is the Idle
adjustment screw.
Position: Left side of the rear handle
(f) Shows the directions that the chain brake is
released (white arrow) and activated (black arrow).
Position: Front of the chain cover
■ EMISSION CONTROL
An emission control label is located on the engine.
IMPORTANT ENGINE INFORMATION
THIS ENGINE MEETS U.S. EPA PH2 AND 2006
CALIFORNIA EMISSION REGULATIONS FOR SI
SORE's COMPLIANCE PERIOD : CATEGORY C
ENGINE FAMILY : 6HCPS.0404AA ; EM
ENGINE DISPLACEMENT : 40cc
REFER TO OWNER'S MANUAL FOR MAINTE-
NANCE SPECIFICATIONS AND ADJUSTMENTS.
MANUFACTURED :
RedMax
MADE IN CHINA

Publicité

Table des Matières
loading

Table des Matières