Table des Matières
Publicité
F39
F40
52
English
11. Maintenance of Saw Chain and Guide Bar
Make sure every cutter has the same length and edge
angles as illustrated. (F39)
(1) Cutter length
(2) Filing angle
(3) Side plate angle
(4) Top plate cutting angle
■ GUIDE BAR
• Reverse the bar occasionally to prevent partial wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
(F40)
(1) Ruler
(2) Gap
(3) No gap
(4) Chain tilts
WARNING
This saw is equipped with one of the following low-
kickback bar/chain combinations:
Bar Size
Guide Bar
Oregon Micro-Lite™ Pro Oregon Micro-Lite™
16" (40cm)
160MPBK041
18" (45cm)
180MPBK041
RedMax Part Number
Saw Chain
95VP-66X
95VP-72X
Publicité
Table des Matières
