Christopeit Sport AP 1 Notice De Montage Et D'utilisation page 16

Step 3:
Attach the handlebar (2) at handlebar support (13).
1. Guide the preassembled handlebar unit (2) through the upper part of
the handlebar post (13) and close the bracket of handlebar holder.
2. Attach the handlebar cover (10) at the handlebar holder of handlebar
support (13).
3. Screw the handlebar (2) in desired position at the handlebar post (13)
with spacer (9) and handlebar screw (8).
Step 4:
Attach the computer (1) at handlebar support (13).
1. Take the computer (1) that has been supplied out of the packaging and
insert the batteries (Type "AA"-1.5 V pencells) by watching for the right
polarity on the back of the computer (1). (Batteries for the computer are
not included in this item. Please buy them at your located market.)
2. Push the plug of the connecting cable (7) projecting from the handlebar
support (13) into the associated socket of the computer (1).
3. Place the computer (1) on top of the handlebar support (13) and tight
firmly by using screw (3).
4. Push the plug of the pulse cable (6) projecting from the handlebar (2)
into the associated socket of the computer (1).
Step 5:
Installation of the saddle (20) on the saddle support (43) and of the
saddle support (43) on the main frame (26).
1. Place the saddle with the seat surface downwards.
2. Place the retaining plate of the saddle support (43) on the upwards
pointing bottom of the saddle (20). The threaded pieces on the bottom of
the saddle must project through the corresponding holes in the retaining
plate of the saddle support.
3. Place washers (42) and spring washers (21) on the threaded pieces,
screw on nuts (41) and tighten firmly.
4. Insert the saddle support (43) into the provided holder of the main frame
(26) and secure at the desired position by screwing in the rapid action
lock (23).
(Note: To screw in the rapid-action lock (23), the threaded hole in the
main frame (26) and one of the holes in the saddle support (43) must be
aligned. Furthermore, ensure that the saddle support (43) is not pulled
out of the main frame beyond the marked maximum adjustment position.
The setting of the saddle support can be adjusted as desired later.) For
this, the rapid-action lock (23) must be loosened by only a few revolutions
(do not unscrew completely), the top cap of the lock must be pulled
away and the saddle adjusted. To set the new position, release the top
cap and move the saddle support upwards and downwards until the
rapid-action lock engages. Then secure the new setting by tightening
the rapid-action lock.)
16