Publicité
6-3 Mounting Method
1)
This is convection cooling type power supply. In consideration of the heat radiation and safety, please keep a dis-
tance of more than 15mm between the power supply and the peripheral parts. When lining up multiple units, please
make sure to place them 5mm or more apart from each other.
2)
Maximum allowable penetration of mounting screws into the power-supply is 5mm.
3)
Recommended torque for mounting screws (M4): 1.27 Nm (13.0 kgfcm).
18
TDK-Lambda
GWS 2
Series
50
INSTRUCTION MANUAL
Publicité
