Publicité
Les langues disponibles
Les langues disponibles
- English -
2. Fit the plug connector of the ECG connection
cable and secure with the two screws (max.
2.0 Nm) (max. 18 lb-in).
• Ensure that the rubber seal is clean and
fits exactly.
• Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT, fit the terminal resistor and secure it with the two screws (max. 2.0 Nm)
(max. 18 lb-in) or another EGC compatible unit.
• No Connection Cable EGC is connected to EGC-OUT on the last unit in the EGC network. The terminal resistor has
to be fitted to this EGC-OUT so that the EGC network is correctly terminated.
• The terminal resistor is included in the delivery scope of the InScenio EGC.
NOTE
The device will be destroyed
if water penetrates the EGC
sockets.
• Close the EGC sockets with
EGC plugs or a protection cap.
Commissioning/start-up
NOTE
Sensitive electrical components. Incorrect connection will destroy the unit.
• Do not connect the unit to a dimmable power supply.
When started up, the pump automatically performs a pre-programmed self-test of approx. two minutes length
(Environmental Function Control (EFC)). The pump detects if it is running dry / blocked or submerged. The pump
switches off automatically after approx. 90 seconds if it runs dry (is blocked). In the event of a malfunction, disconnect the
power supply and flood the pump or remove the obstacle. Following this, the unit can be restarted.
• Switching on: Connect the unit to the mains. The unit switches on immediately.
• Switching off: Disconnect the unit from the mains.
Seasonal Flow Control (SFC)
1. Press and slide the switch.
• ON is indicated on the switch. The function is
activated.
• ON is concealed on the switch. The function is
deactivated.
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
9
Publicité
