Supplied Components; Preparing The Remote Control Unit And The Touch Pen - Sharp PN-L703A Manuel D'installation

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 3
 Cable clamp (insertion type): 2
 Power cord
 Remote control unit battery
(R-6 battery ("AA" size)): 2
* Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.

Preparing the Remote Control Unit and the Touch Pen

Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
Connecting the touch pen adapter
To use the touch pen, insert the touch pen adapter into the
touch pen adapter port on the monitor.
Touch pen
adapter port
Touch pen
adaptor

Supplied Components

 CD-ROM (Utility Disk): 1
 CD-ROM (Touch Display Link): 1
 Touch Display Link License: 1
 Setup Manual: 1
 Touch pen: 1
 Touch pen adapter: 1
 Pen tip (for touch pen): 2
 Touch pen battery
(LR-03 ("AAA" size)): 1
 Tray: 1
 USB cable: 1
Inserting the battery
1. Remove the battery cap.
2. Open the cover and insert the supplied battery (AAA
size) into the touch pen.
Check the plus (+) and minus (-) markings on the inside
of the touch pen and insert the battery in the correct
orientation.
3. Replace the cover and battery cap.
TIPS
• Calibration must be performed prior to initial use of the
touch pen.
• To use an optional touch pen with the monitor, the touch
pen must be registered in the touch pen adapter. For
details, see the operation manual.
Touch pen
adapter screw
(anti-theft)
 Eraser: 1
 Camera mount: 1
 Camera screw (inch thread): 1
 Touch pen adapter screw (Step screw, M3): 1
 Tray mounting screws (M3) : 5
 Cover Sharp logo: 1
Place this sticker onto the SHARP logo to cover
the logo.
2
Battery cap
1
5
E