Connections - Sharp PN-L703A Manuel D'installation

Caution
• Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting
cables. Also, read the manual of the equipment to be connected.
• Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables
connected to the input and output terminals may cause malfunctions and the other problems.
1
2
For power outlet
TIPS
• Set the audio input terminal to be used in each input mode in AUDIO SELECT on the SETUP menu. The factory settings are
shown below.
Input mode
D-SUB1
D-SUB2
DisplayPort
HDMI1
HDMI2
HDMI3
WHITEBOARD
• To use the touch panel with a computer connected to the monitor, the touch panel and computer must be connected, and
Touch Panel Settings Tool, Touch Pen Utility, and Pen Software must be installed on the computer from the provided CD-
ROM.
To install the software, see the manual for each.
• To use a touch panel with a computer connected to the bottom, connect to the USB1 port.
To use a touch panel with a computer connected to the side, connect to the USB2 port.
(Factory setting. Can be changed in INPUT SELECT in the SETUP menu.)
• HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing
LLC.
• DisplayPort is a registered trademark of Video Electronics Standards Association.
6
E

Connections

3 4 5 6 7 8
Audio input terminal (Factory setting)
Audio1 input terminal
Audio2 input terminal
DisplayPort input terminal
HDMI 1 input terminal
HDMI 2 input terminal
HDMI 3 input terminal
WHITEBOARD
1. AC input terminal
2. External speaker terminals
17
3. Audio output terminal
4. DisplayPort output terminal
18
5. Touch pen adapter port
6. USB 1 port
12
7. LAN terminal
8. D-sub 1 input terminal
13
9. DisplayPort input terminal
10. HDMI 1 input terminal
11. Audio 1 input terminal
14
12. USB 2 port
15
13. D-sub 2 input terminal
14. HDMI 2 input terminal
16
15. HDMI 3 input terminal
16. Audio 2 input terminal
WHITEBOARD mode terminals
17. USB ports
9 10 11
18. LAN terminal