Further Safety Directions; Operation.startup; Tensioning The Saw Chain - FLORABEST FKS 2200 C2 Traduction Du Mode D'emploi D'origine

GB
Kickback is the result of tool misuse and/
or incorrect operating procedures or condi-
tions and can be avoided by taking proper
precautions as given below:
Maintain.a.firm.grip,.with.thumbs.
•
and.fingers.encircling.the.chain.
saw.handles,.with.both.hands.on.
the.saw.and.position.your.body.
and.arm.to.allow.you.to.resist.
kickback.forces. Kickback forces can
be controlled by the operator, if proper
precautions are taken. Do not let go of
the chain saw.
Do.not.overreach.and.do.not.cut.
•
above.shoulder.height..This helps
prevent unintended tip contact and ena-
bles better control of the chain saw in
unexpected situations.
Only.use.replacement.bars.and.
•
chains.specified.by.the.manufac-
turer..Incorrect replacement bars and
chains may cause chain breakage and/
or kickback.
Follow.the.manufacturer´s.sharp-
•
ening.and.maintenance.instruc-
tions.for.the.saw.chain..Decreasing
the depth gauge height can lead to
increased kickback.

Further safety directions

• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Lay the extension cable in such a way
that it will not be caught by branches
or similar during sawing.
• Use a surge protector with a release cur-
rent of 30 mA or less.
• Comply carefully with maintenance,
control and service instructions in
58
this manual. Damaged protective de-
vices and parts have to be repared or
changed except as noted otherwise in
this manual.
Operation startup
. Always.wear.protective.
gloves.when.working.with.
the.chainsaw.and.employ.
only.original.parts..Pull.out.
the.power.plug.before.doing.
any.work.on.the.chainsaw.
itself.-–.injury.hazard!
The tool is completely assembled on deliv-
ery.Before you start up the electric chain-
saw, adjust the chain, fill up with chain oil
and check the automatic lubrication and
chain brake function.
Note that the saw can re-oil.
Please note that the saw re-oils after use
and oil may leak out if it is stored on its
side or on the head. This is a normal
process due to the necessary ventilation
opening on the upper edge of the tank and
does not constitute a reason for complaint.
As each saw is checked during production
and tested with oil, a small residue may
be in the tank despite draining, which may
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.

Tensioning the saw chain

With a correctly tensioned chain you get
good cutting performance and a longer
life.
. An.incorrectly.tensioned.
chain.may.break.or.spring.
off,.leading.to.danger.of.