Télécharger Imprimer la page

Tristar VE-5923 Mode D'emploi page 12

Masquer les pouces Voir aussi pour VE-5923:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 6
EN
General safety instructions
Check if the tension of your supply corresponds with the voltage indicated on the rating plate of your appliance.
Before commissioning this device please read the instruction manual carefully and keep this so that you can check them later .
Please keep these instructions, the guarantee certificate, the sales receipt and, if possible, the carton with the inner packaging!
The device is intended exclusively for private and not for commercial use! Keep it away from direct heat, sun and moist and
protect it against sharp impacts.
Always remove the plug from the socket whenever the device is not in use, when attaching accessory parts, cleaning the device or
whenever a disturbance occurs. Switch off the device before. Pull on the plug, not on the cable.
This appliance is not intended for use by persons with reduced physical, sensory or mental capacities , or lack of experience and
knowledge (including children) , unless they have been supervised or instructed concerning use of the appliance by a person
responsible for their safety.
In order to protect children from the dangers of electrical appliances, never leave them unsupervised with the device.
Consequently, when selecting the location for your device, do so in such a way that children do not have access to the device.
Take care to ensure that the cable does not hang down.
Test the device, plug and the cable regularly for damage. If there is damage of any kind, the device should not be used but the
appliance must be repaired by a qualified technician in order to avoid a hazard. Only original spare parts must be used.
A damaged cord or plug must be replaced by an authorized technician to avoid a hazard. Do not repair the device yourself,.
Keep the device and the cable away from heat, direct sunlight, moisture, sharp edges and such like.
Never use the device unsupervised! Switch off the device whenever you are not using it, even if this is only for a moment.
Do not use the device outdoors.
Under no circumstances must the device be placed in water or other liquid, or come into contact with such. Do not use the device
with wet or moist hands.
Should the device become moist or wet, remove the mains plug from the socket immediately. Do not reach into the water.
Use the device only for the intended purpose.
Instruction manual for fans
A) PARTS DIAGRAM
1 ) Front guard
2) Spinner
3) Fan-blade
4) Ring
5) Rear guard
6) Clip
7) Rustproof
8) Shaft
9) Motor plastic cover
10) Oscillation knob
11 ) Neck joint
12) Speed switch
A+B) ASSEMBLING INSTRUCTIONS
1. Unscrew the spinner by turning clockwise and the ring by turning counter -clockwise.
2. Mount the rear guard to the motor by matching the holes on the rear guard to the round pins on the motor housing. Push in
firmly until the pins protrude through the holes.
3. Secure the rear guard to motor housing with the ring.
4. Insert the blade onto motor shaft by matching slots in the blade with pin in shaft and tighten the blade with the ring by turning
counter- clockwise.
5. Test blade by rotating with your hand. Make sure there Is no friction with the ring. Blade should rotate freely otherwise repeat the
steps again
6. Mount front guard onto rear guard by inserting the back side of the front guard over rear guard and secure with the screw
supplied and with clips on front guard,
B) PARTS DIAGRAM
1 ) Front guard
2) Spinneer
3) Fan-blade
4) Plastic-nut
5) Rear guard
6) Clip
7) Motor shaft
8) Clutch knob
9) Adjustment screw
10) Speed control
11) Thumb screw
12) Height adjustment knob
13) Extension pipe
14) Column
15) Stand ornament
16) Four screws
1 7 ) Stand
12

Publicité

loading

Ce manuel est également adapté pour:

Ve-5930Ve-5948