Technical Data; Installation - ZANKER KBB24001SK Notice D'utilisation

4. Install the lamp cover.
5. Tighten the screw to the lamp cover.

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
6.
7.
Height
Width
Depth
with current regulations, consulting a qualified electri-
cian.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance opens to the right. If you
want to open the door to the left, do these steps before
you install the appliance:
Loosen the upper pin and
remove the spacer.
Remove the upper pin
and the upper door.
Connect the plug to the mains socket.
Open the door. Make sure that the light comes on.
1446 mm
560 mm
550 mm
20 h
230-240 V
50 Hz
Loosen the middle hinge.
23