Technical Data - ZANKER KBT23001SB Notice D'utilisation

Problem
It is too cold inside the freez-
er
The appliance does not work
at all. The appliance does not
cool at all. Neither cooling
nor lighting works
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power and
specifically designed for household appliances
(the maximum power is shown on the light bulb
cover).
5. Fix the lamp cover in place.

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
Possible cause
Food placed in the appliance was
too warm
Products to be frozen are placed too
closely to each other
Temperature Regulator may be set
incorrectly
The appliance may be switched off
Plug is not connected to the mains
socket properly
Power does not reach the appliance
There is no voltage in the mains
socket (try to connect another appli-
ance into it)
Height
Width
Depth
Allow food to cool to room temperature
before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Switch on the appliance
Connect the mains plug properly
Try connecting another electrical de-
vice to the power outlet
Call an electrician
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.
1446 mm
560 mm
550 mm
20 h
230-240 V
50 Hz
Solution
21