Technical Data; Installation - ZANKER KBA14411SK Notice D'utilisation

Problem
The temperature in the appli-
ance is too high.
Replacing the bulb
If you want to replace the bulb, do these steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as shown in
the figure.
4. Replace the bulb with one of the same power and
specifically designed for household appliances (the
maximum power is shown on the light bulb cover).
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light comes on.

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
This appliance should be installed in a dry, well ventila-
ted indoor where the ambient temperature corresponds
Possible cause
The temperature regulator is not set
correctly.
Height
Width
Depth
Set a lower temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installa-
tion".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
873 mm
540 mm
549 mm
12 h
230 V
50 Hz
to the climate class indicated on the rating plate of the
appliance:
Solution
19