Beta 3067/60-15T Mode D'emploi page 10

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
Lubrication
The air hydraulic jack must be connected to a filter-lubricator unit with an air-oil microfog mixer
(we recommend Beta item 1919F1/4), set at two drops per minute. This will result in a high-performing
tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, to lubricate the compressed air circuit use the following oils:
• AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100; SHELL TELLUS 100; BP ENERGOL HP 100.
HOW TO USE AIR HYDRAULIC JACK
Lift vehicles as follows:
• Position the jack under the supports as described in the manual of the vehicle manufacturer.
• Use the extensions supplied with the jack together with the relevant plate, if need be. (pict.13)
• The handle positioning lever is on the left of the operator; lifting it will cause the handle to be released,
thereby allowing the operator to choose one of the three possible positions of the handle.
• When control lever B is placed perfectly central, the jack is at rest.
• Shifting control lever B to the right of the operator will cause the jack to go up.
• Shifting control lever B to the left of the operator will cause the jack to go down. (pict.13).
• After lifting the vehicle, before carrying out any jobs under it, place it on suitable stands.
Before lowering the load, check that the handle is in the horizontal position.
Do not stand under the load before placing it on suitable stands.
Before starting lifting operations, secure the vehicle with the emergency brake and/or place two
wedges at the wheels.
In case the distributor should break down during operation, close the safety cock to stop the air flow
(pict.14).
• After the jack has been used or if it is not used for prolonged periods, the pistons should be completely
down, and the jack should be stored in a safe, suitable place.
Accessories
The jack is supplied with two extensions or height adapters (70 and 120 mm) and a circular tooth plate (10 mm).
DISPOSAL
The jack must be disposed of in compliance with the laws in force in the country where it is used.
WARRANTY
This equipment is manufactured and tested in accordance with current EU regulations, and is covered by
a 12-month warranty for professional use and a 24-month warranty for non professional use respectively.
We will repair any breakdowns caused by material or manufacturing defects by fixing or replacing the
defective pieces or replacing them at our discretion. Should assistance be required once or several
times during the warranty period, the expiry date of this warranty will remain unchanged. This warranty will not
cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In addition, this warranty will
no longer be valid if any changes are made, or if the jack is forced or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
DECLARATION OF CONFORMITY
We hereby declare, assuming full responsibility, that the described product complies with all the relevant
provisions of Machine Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN 1494
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845 Sovico (MB)
ITALY
10
EN I