IKA ULTRA -TURRAX Tube Drive Mode D'emploi page 14

Setting Timer (Changing of mode)
Switch off the device.
Minutes-mode
Press and hold "Start/STOP" button (C),
and also press the "Power" button (A).
Minutes-mode display:
The time that was previously set will be
stored, e.g.:
Note: max. 29 min., speed range upto
4000 rpm.
Seconds-mode
Press and hold "Start/STOP" button (C),
and also press the "Power" button (A).
Seconds-mode display:
The time that was previously set will be
stored, e.g.:
Note: max. 59 sec, speed range upto
6000 rpm.
Setting the time
The time that was previously set will be
stored, e.g.:
(Factory setting: 00)
10 1
Set the tens digit Set the ones digit
using button (E). using button (D).
Attaching the tube
Fit the tube carefully and ensure it is properly
attached.
Setting the speed
Set the desired speed in the range of 300–
6000 rpm using the infinitely adjustable raro-
tary knob (B).
Starting
Press "Start/Stop" button (C),
while the preset countdown is running, timer
display will blink.
An audible signal will be given when
the countdown is complete.
Cancelling the countdown
Press button "Start/Stop "(C).
Switching off
Press button "Power" (A).
14