switel WTF722 Mode D'emploi page 62

Operating the Walkie−Talkies
Searching for a channel
Signals are searched for in the eight channels in a continuous cy-
cle. The
tected, the channel search stops. The Ready LED flashes once per
second. Press the P button to enable radio communication. If
the P button is not pressed or the channel is inactive, channel
search resumes after five seconds.
Start / End channel search
N
Resuming search for a channel
: or ;
Excluding a channel
35
If a channel found during the channel search process should not be
considered for subsequent use, it can be excluded. All the channels
are taken into consideration again when a new channel search is
started.
a, : or ;
Defining a group of channels
36
It is possible to define a group for the channel search. Scroll
through all the channels and define whether the individual channel
should be considered in the channel search or not.
7 x M
: or ; [ y ]
P
62
icon appears in the display. If an active channel is de-
Even if Group Scan feature is activated, in order to start
Group Scan in standby mode by pressing N, you must
have configured more than one group channel except
home channel. (Home channel is the channel you cur-
rently configured, when start to scan, the radio searches
from home channel. In Group Scan, the home channel is
considered as priority channel if it is not set to group chan-
nel). Otherwise, the radio will operate as normal scan.
Start/End the search for a channel
Continue the search for a channel
The channel is excluded and the
channel search automatically
resumed
Activate Group channel
Add or exclude the channel
and confirm it