EUROM NARVIK Mode D'emploi page 28

Push-button operation
If you don't use the remote control, you can press the relevant buttons on the control
panel, manually set it to 3 positions; the corresponding lights will turn on.
- I/O : flame effect only
- I/O + 1000W : flame display and heating at 1000W
- I/O + 2000W : flame display and heating at 2000 Watt (all the lights are turned on).
By pressing the I/O button longer, you initiate the dimmer function; the light intensity
will increase or decrease with every tweet. Release the button when you have
achieved the desired intensity
Attention! The thermostat cannot be set manually, only with the remote control. The
thermostat is standard set to 20°C.
Remote control:

Press on the ON/OFF button to switch on the stove.
 Now set the desired temperature. The temperature & timer setting will usually
show the ambient temperature. By pressing on the + or - button, you see the set
temperature flashing for a short time and by pressing the + or - buttons, you can
adjust the temperature (from 15 to 30°C). After a few seconds, the display
switches back to the ambient temperature and the newly desired temperature is
set. The temperature is standard set to 20°C.
 Now you can start operating the stove by pressing the button to 1000W (half
output) or 2000W (full output). When the set temperature is above the ambient
temperature, the stove will start to heat. If you press the IC button, the stove will
automatically choose the most suitable output: up to 6° temperature difference =
half output; more than 6° temperature difference = full output. The corresponding
lights on the display are turned on (1 star, 2 stars or AUTO).
 The thermostat will switch off the stove as soon as the stove reaches the desired
temperature and it will switch it on again if the ambient temperature drops.
 By pressing the 'dimmer' button (there are 5 positions), you can intensity or
decrease the flame effect of the stove.
 You switch off the stove by pressing the ON/OFF button. The temperature level
that you set will remain. However, if you switch on the stove once again, you will
have to reset the output.
 If you want to switch off the stove for a longer period, then also set the main
switch on O (OFF). The set temperature will now be erased. Finally remove the
plug from the socket.
TIMER
 The stove has a built-in weekly timer, which allows you to set a weekly schedule
for switching on and off. You must first set the date and time; if you don't do
that, then the stove assumes that it is scheduled for Sunday at 00.00!

Press the ON/OFF button to switch on the stove.

Press on the DAY/TIME button; the day indicator will light up. Select the
arrows Λ and V for the current day and confirm this by pressing the
DAY/TIME button again (Sunday, Monday, etc.)
28
28