EUROM NARVIK Mode D'emploi page 27


Hang the glass plate (two people are needed for this job!) with the four hooks
over the four knobs on the sides of the fireplace and check that all four hooks are
correctly attached (see diagram 4). Lower the glass plate as far as possible.

Installation is now complete.
OPERATING

Check that the details on the data plate correspond to those of the electrical
supply which you wish to use for the fireplace. Do not use the same connection
for any other equipment.

Install two AAA-1,5V batteries in the remote control.

Check whether the main switch is set to OFF (O is pushed in)

Now insert the plug into the grounded socket.

Push the main switch to ON (I is pushed in). The stove is now on stand-by and
the light is switched on at the

You can now further operate the fireplace with the remote control or with the
buttons on the fireplace itself.
Note: ensure that the weight of the fireplace
hangs on the wall supports
and not on the spacer bracket!
27
27