Publicité
Les langues disponibles
Les langues disponibles
Display:
1. Stand-by light
2. Day indicator
3. Temperature and thermostat setting
4. Time indicator and timer setting
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Do not use the fireplace before it has been completely installed according to the
instructions and you have read the instruction booklet fully!
This device was designed to be permanently hung on a wall. Ensure the wall is
sturdy, completely vertical, is not sensitive to vibration and is not flammable.
Make sure it is not made of synthetic material and or covered with flammable
material. Be aware of pipes that may be contained within the walls when drilling
holes.
Choose a suitable location for the fireplace, at least one metre from all
obstructions, walls and flammable materials (see safety instructions) and in the
vicinity of a 16 Amp (at least) fused, earthed electrical socket (protected by a 30
mA earth leakage circuit breaker). This socket must be located to the right of the
fireplace.
There must be at least 30 cm distance between the base of the fireplace and the
ground, however, you are advised to place the fireplace at a height of 60 cm. for
the best sight. There must be at least 20 cm distance between the fireplace and
the side walls, at least 100 cm. between the fireplace and the ceiling. Do not
hang the device directly under or in front of an electrical socket (see diagram 1).
The wall supports must be attached horizontally (use a spirit level!) to the wall.
Determine the location of the wall supports (take the above into account), mark
the location of the screws and drill 4 holes at the marked places using a 6 mm
drill. Put the plugs into the holes and then screw the wall supports to the wall. Be
aware of pipes that may be contained within the walls when drilling holes!
Attach the spacer bracket with both self-tapping screws underneath the fireplace
in the holes provided. The flat side of the bracket must be placed against the
underside of the fireplace; the other must rest against the wall so that the wall
piece sticks out under the fireplace (diagram 3). This bracket will be hidden from
sight once the glass screen has been installed.
Now hang the fireplace carefully on the central wall support with the hanging
bracket (see diagram 2). The bracket should not stick out from the support! The
electrical cable comes out at the right hand, lower side of the fireplace and must
be placed out of range of the heat.
Now mark the location at which the spacer bracket must be screwed to the wall.
Remove the fireplace from the wall, drill both holes and insert a plug. Hang the
fireplace on the bracket and screw the spacer bracket to the wall.
26
5. Lamps of 1000W - 2000W - auto
6. Dimmer setting
7. Operating timer light
8. Timer ON & OFF setting
26
Publicité
