Bodum 11515 Mode D'emploi page 7

– Never attempt to replace the
power cord of the appliance, since
special tools are required for this
purpose. You should only have the
repair or replacement of the power
cord performed by a manufacturer
authorized repair shop, in order to
ensure the safety of the appliance.
– You should not Immerse the cord,
motor housing and plug in water or any
other liquid as this can lead to fire,
electric shock or injury.
– While cleaning, the appliance should
not be connected to power.
– Do not touch any of the rotating parts.
– Keep hair, fingers and utensils away
from the rotating parts, in order to
avoid severe personal injury and
damage to the appliance.
– The blades are sharp, handle these
with care.
– Before changing accessories or
attachments that move during
operation, the appliance must be
turned off and unplugged.
– In order to prevent possible injury due
to incorrect handling. Be careful with
the handling of the sharp blades, when
emptying the vegetable slicer and when
cleaning.
– You should never swith on the
appliance with a damaged accessory.
Check the appliance and the accessory
before and after each use for damage.
– Handle the accessory with care.
– The blades of the drum can
cause injury.
– Make sure before use that no foreign
objects are in the vegetable slicer.
– Never feed food by hand. Always use
food pusher.
8
SAVE tHESE
InStRuCtIonS
uSE tHIS AttACHmEnt onLY
toGEtHER WItH tHE BIStRo
StAnD mIxER moDEL 11381!
LEGEND
1 Slicer Shredder housing
2 Bayonet
3 Plunger
4 Mounting ring
5 Coarse shredding drum
6 Fine shredding drum
7 Slicing drum
8 Parmesan grating drum
SLICER SHREDDER ASSEMBLy
1. Insert the desired drum (5-8) into
the housing (1). (Fig. 1)
2. Insert the mounting ring (4) on
the housing and turn it counter-
clockwise up to the stop. Make sure
that the open side of the mounting
ring is facing downwards. (Fig.2)
FITTING THE SLICER SHREDDER
ONTO THE STAND MIXER
1. Switch the speed control of the
Stand Mixer to "stop". Make sure
that the ON/OFF switch is in the
"OFF" position and the power cord
is unplugged.
2. Remove the cover of the accessory
connector by pressing on the top
area (Fig. 3). Store the cover,
in order to close the accessory
connector again after use.
3. Press the connector of the Slicer
Shredder into the accessory port