HQ Power AERON 150S Notice D'emploi page 6

o Start Address Selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDP150MH7.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDP150MH7s will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 7-channel VDP150MH7, you will have to set the start address of the first VDP150MH7 to 1, the
second VDP150MH7 to 8 (1 + 7), the third to 15 (8 + 7) and so on.
o Detailed DMX Values per Channel
Channel
1
2
3
4
5
6
7
c. Settings
• Pan / Tilt Reverse
Reverse Tilt movement reverse. Press the jog wheel and turn it in an anti-clockwise direction. Press again to
Tilt Y confirm.
Reverse Tilt movement not reverse. Press the jog wheel and turn it in a clockwise direction. Press again to
Tilt N confirm.
VDP150MH7
Description
Dimmer / strobe
Colour wheel
Gobo wheel
Pan movement
Tilt movement
Speed pan / tilt
Gobo rotation
From To Function
0 127 Dimmer from 0 – 100%
128 247 Strobe from slow to fast
248 255 Open
0 15 White
16 31 Magenta
32 47 Yellow
48 63 Orange
64 79 Green
80 95 Red
96 111 Blue
112 127 Purple
128 255 Rotation from slow to fast
0 15 Open
16 31 Gobo 1
32 47 Gobo 2
48 63 Gobo 3
64 79 Gobo 4
80 95 Gobo 5
96 11 Gobo 6
112 127 Gobo 7
128 255 Gobo rotation from slow to fast
0 255 Max. 540°
0 255 Max. 280°
0 255 Speed adjustment from slow to fast
0 131 Clockwise rotation from slow to fast
132 255 Anti-clockwise from slow to fast
6 HQPOWER