Operating - Bartscher Contessa Duo Mode D'emploi

5.3 Operating

Prior to first use
•
Prior to first use it is necessary to run 2 or 3 cycles of water through the machine
without coffee, in order to properly rinse the unit („Preparation of coffee" steps 1-8).
•
Due to the nature of the system a small amount of water always remains in the
container for water. It is necessary to take this into account when refilling the container.
•
Always fill the water container with an
amount of water equal to the capacity
of the thermo pump jug included with
the coffee machine. The amount of
coffee brewed will be the same as the
amount of water poured.
•
If too much water is poured into the
water container, excess water will
drain out through the flow hose.
•
The thermo jug and filter basket should be thoroughly washed in warm water and a
mild cleaning agent, then rinsed in clean water. Dry thoroughly after washing.
•
The unit's casing should be wiped with a moist cloth and dried with a soft towel.
•
Connect the unit to an appropriate power source which serves one piece of
equipment.
•
The coffee machine is now ready for use.
•
The drip coffee stations can be used simultaneously or separately, as needs dictate.
Preparation of coffee
1. Remove the filter basket (7) and place the proper Bartscher paper filter (Code-No.:
A190.002) inside.
2. Pour a proper amount of ground coffee into the paper filter. Use 35 to 50 g of coffee
per one litre of water, in accordance with your preferences.
3. Replace the filter basket (7) and slide to the very back until it "clicks" into place.
- 26 -
Flow hose