Machine Setup; Installing Pad; Installing Dust Control Bag - Nobles SpeedGleam Manuel Opérateur

OPERATION
ATTENTION: Do not drop batteries into
compartment. Battery and machine housing
damage may result.
5. Before connecting the battery cables, make sure
the terminals and posts are clean. Use a post
cleaner and wire brush if necessary.
NOTE: Apply a light coating of non-metallic grease or
protective spray on the cable connections to prevent
battery corrosion.
6. Using the cable boots, connect the battery cables
to the battery posts as shown, RED TO POSITIVE
& BLACK TO NEGATIVE (Figure 3).
NOTE:
Black wire #31
WIRES
connects to negative
FROM
post on middle battery.
CHARGER
BLK/WHT
RED
31
BLK
7. Double check cable connections and close hood,
fasten hood latches.

MACHINE SETUP

INSTALLING PAD

NOTE: Consult your authorized distributor for pad
recommendations.
Pad Specifications required:
S
For 2000 RPM burnishing.
S
25.4mm (1.0 in) thickness
S
508mm (20 in) dia. with 89mm (3.5 in) center hole.
NOTE: Machine is not designed for spray buffing.
1. Turn the main power switch off and tilt the
machine back on its rear wheels (Figure 4).
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
NOTE: When machine is tilted back completely, power
to pad motor automatically shuts off.
8
IMPORTANT:
Route cables to left
of machine to allow
hood clearance.
BLK
RED
Connect Last
MACHINE
FRONT
FIG. 3
ATTENTION: Do not leave machine tilted back for
an extended time, battery acid may leak.
2. Attach the pad to the pad driver and secure pad
with centerlock (Figure 5).
ATTENTION: Do not operate machine without a
pad and/or centerlock in place.
3. After installing pad, return machine to operating
position.

INSTALLING DUST CONTROL BAG

1. Open the dust control bag compartment at the
front of the machine.
2. Slide the bag over the plastic snout. Close
compartment (Figure 6).
FIG. 4
FIG. 5
FIG. 6
Nobles SpeedGleam/Plus (08- 08)