EN
Oszillo-saw GOLD II accu autopsy
3 Scope
The use of oscillating plaster saws mainly takes place in orthopedics for plaster removal.
3.1 Inteded Use
A hand-held, power-driven (AC) product for cutting gypsum or synthetic material usually during the
removal of a plaster cast. The proximal end (the handle) is usually cylindrical, while the distal end
terminates in a round, crescent-shaped, or circular blade suitable for cutting plaster casting material. The
leaves cut as an electric motor in the handle drives them (swinging). The cut is done by vibration rather
than by sawing.
3.2 Contraindications
There are no known contraindications.
4 Accumulator
To take off the accumulator press the red coloured button to
unlock it. At the same time pull the accumulator upwards off the
saw, see
fig. 1
To attach to accumulator, pull it from top onto the rails until
your hear it snap in.
fig. 1 Removing the accumulator
Accumulator status
To check the charge status of the accumulator, press the red button located on the side of the
accumulator, like in fig. 2. The real percentage of the battery charge condition is only indicated
when the power tool motor is stopped.
fig. 2 Accumulator status
20