Operation; General Information; Select Video Input - Renkforce 419700 Notice D'emploi

8. Operation

a) General Information
Settings in the menu/OSD (= On-Screen-Display) of the screen may be performed both with the buttons on
the monitor or on the enclosed IR remote control.
Some special functions are, however, only possible with the IR remote control.
The button assignments are as follows:
IR remote control
Button " "
Button "MENU"
Button ◄
Button ►
Button ▼
Button ▲
Button " "
Button "INPUT"
Button "PICTURE"
Button "FREEZE"
b) Select Video Input
The video input can only be selected when no OSD menu is displayed.
• Push the button "INPUT" on the IR-remote control or the button "SOURCE" at the monitor.
A display with the 4 inputs "AV1", "AV2", "HDMI" and "VGA" appears at the top left of the monitor.
• Use the buttons ▲or ▼on the IR-remote control or "SOURCE" on the monitor to select the desire input.
• Confirm your selection with the button ►on the IR-remote control or the button "UP/+" at the monitor. Then the
selected input is activated and a video signal pending there is displayed.
If no video signal is recognised, the display shows "NO SIGNAL".
Monitor
Button "POWER"
Button "MENU"
Button "DOWN/-"
Button "UP/+"
Button "SOURCE"
-
-
Button "SOURCE"
-
-
Function
Switching monitor on/off
Call or leave the menu/OSD
Reduce set value in the OSD
Increase set value in the OSD
Select function in the OSD
Select function in the OSD
Mute audio playback
Activate input switching mode (VGA, HDMI, AV1, AV2)
Select image mode ("USER", "STANDARD", "SOFT", "VIVID")
Picture "freeze"
29