Operation; General Information; Hdmi-Input „Hdmi-In - Renkforce 396412 Notice D'emploi

8. Operation

a) General Information
Settings in the menu/OSD (= On-Screen-Display) of the screen may be performed both with the
buttons on the screen or on the enclosed IR remote control.
Some special functions are, however, only possible with the IR remote control.
The button assignments are as follows:
IR remote control
Button „ "
Button „MENU"
Button „t"
Button „u"
Button „q"
Button „p"
Button „MUTE"
Button „INPUT"
Button „PICTURE"
Button „FREEZE"
b) HDMI-input „HDMI-IN"
When the HDMI-input is selected and you push the button „MENU", the associated OSD menu is displayed.
The OSD menu is operated as follows:
• The buttons „t" or „u" on the IR-remote control (or „UP/+" and „DOWN/-" on the monitor) are used to
select between the submenu „PICTURE", „OSD", „FUNCTION" and „AUDIO".
• The button „p" or „q" on the IR-remote control (or „AUTO" on the monitor) can be used to select the
functions.
• The buttons „t" or „u" on the IR-remote control (or „UP/+" and „DOWN/-" on the monitor) are used to
select the respective set values.
• If you have completed the settings, the button „MENU" will take you back to the selection of the subme-
nu „PICTURE", „OSD", „FUNCTION" and „AUDIO" .
Leave the OSD menu by pushing the button „MENU" again. Alternatively, wait without pushing a button
until the display of the OSD menu disappears on its own.
30
Screen Function
Button „POWER" Switching motor on/off
Button „MENU" Call or leave the menu/OSD
Button „DOWN/-" Reduce set value in the OSD
Button „UP/+" Increase set value in the OSD
Button „AUTO" Select function in the OSD or select automatic image calibration
in the VGA mode
- Select function in the OSD
- Mute audio playback
Button „AUTO" Activate input switching mode (VGA, HDMI, AV1, AV2)
- Select image mode („USER", „STANDARD", „SOFT")
- Picture „freeze"