Life & Mobility Match Semi-actif inclinable Mode D'emploi page 32

Settings and adjustments
Balance point settings
1. Loosen the 2 socket screws (A).
Attention: Only unscrew the front
socket screw entirely from the clamp
block. The rear socket screw must never
be completely removed as it limits
backwards sliding of the assembly plate.
Tip: You can use the extension tool
included in the delivery for the requisite
Allen key to get good access to both
socket screws of the balance point
adjustment.
2. Slide the seat frame to the front or the
rear until the optimum position has been
found.
Tip: Keep to the green or orange area of
the graduation, which is visible through
the peephole (B) on the side of the frame.
3. Retighten the 2 socket screws (A).
Seat angle
The seat angle can be adjusted easily by
control lever (C) on the right push bar.
Attention:
• At the lowest setting of seat height
adjustment column 1 (the shortest),
the seat angle tilt range is limited to
0˚ frontward.
• If the moulded seat is very wide, the
seat angle tilt range can be limited
due to the maximum track width of
the rear wheels.
Adjusting the seat angle
1. Squeeze the right control lever (C) to
disconnect the dampers.
2. Set the seat angle required.
3. Release the control lever again.
EN22
A
Balance point callibration
B
Balance point calibration peephole
C
D
Adjusting the seat angle
A
Calibrating the seat angle indicator
B
C
Adjust the seat angle indicator
Settings and adjustments
Seat angle indicator
The user can indicate what the best seat
angles or seat angle areas are with the seat
angle indicator (D).
Attention:
• Make sure the seat angle indicator
is properly calibrated before the
optimum seat angle / seat angle
areas are set.
Calibrating the seat angle indicator
1. Tilt the wheelchair until the assembly
plate is horizontal.
2. Loosen the socket screws (A) on the
bottom of the seat angle indicator a bit.
3. Rotate the seat angle indicator (B) until
the lower edge of the air bubble is on the
0˚ line.
4. Retighten the socket screws.
Adjust the seat angle indicator
1. Set the seat angle required.
2. Use the tip of a pen to slide two of the
four bolts (C) above and below the air
bubble on the side of the housing
3. Repeat this with the other 2 bolts for a
second seat angle to be indicated.
Tip: If only 1 set of bolts is used, the other
set can be slid completely upwards and
downwards.
Seat angle range
The seat-tilt range is from -5 to 30°. This range
can be limited on the front (limiting forward
tilt) and on the rear (limiting backward tilt). To
do so, move the 2 locking pins in the hole
pattern on the discs under the seat frame.
EN23