EINHELL BT-BD 401 Mode D'emploi D'origine page 14

Anleitung_BT_BD_401_501_SPK7:_
GB
9. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
9.1 Cleaning
The drill is maintenance-free to a large extent.
Keep the equipment clean. Pull the power plug
before doing any cleaning and maintenance work
on the appliance. Do not use any harsh, abrasive
solvents to clean. Ensure that no liquid seeps into
the equipment. Regrease all bare parts when the
work is finished. The drill pillar, blank parts of the
column, and the drill table especially should be
regreased at regular intervals. Use a standard,
acid-free lubricating grease to do this.
Important: Do not use your household trash can
as a receptacle for oil and grease-soaked
cleaning rags or grease and oil sludge. Dispose
of these toxic materials in an environmentally-
friendly fashion. Regularly check and clean the
ventilation holes. Store the equipment in a dry
room. Should the equipment become damaged,
do not try to repair it yourself. Leave this work to
the hands of a qualified electrical technician.
We recommend that you clean the equipment
immediately after you use it.
Clean the appliance regularly with a damp cloth
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the appliance. Ensure that no
water can get into the interior of the equipment.
9.2 Servicing
There are no parts inside the equipment which
require additional maintenance.
9.3 Ordering replacement parts:
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
14
31.08.2009 13:19 Uhr Seite 14
10. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.