EINHELL BT-BD 401 Mode D'emploi D'origine page 11

Anleitung_BT_BD_401_501_SPK7:_
5. Technical data
BT-BD 401
Nominal input voltage
Power rating
Operating mode
Motor speed
Output speed
Speed levels
Drill chuck mount
Scroll chuck
Max. shaft diameter
Reach
Drill depth
Pillar diameter
Height
Weight
L sound pressure level
pA
L sound power level
WA
K uncertainty
pA
K uncertainty
WA
BT-BD 501
Nominal input voltage
Power rating
Operating mode
Motor speed
Output speed
Speed levels
Drill chuck mount
Scroll chuck
Max. shaft diameter
Reach
Drill depth
Pillar diameter
Height
Weight
L sound pressure level
pA
L sound power level
WA
K uncertainty
pA
K uncertainty
WA
31.08.2009 13:19 Uhr
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
230V ~ 50 Hz
Load factor:
A load factor of S2 15 min (intermittent periodic duty)
350 W
means that you may operate the motor continuously
S2 15 min.
at its nominal power level (350/500 W) for no longer
than the time stipulated on the specifications label (15
1,400 rpm
minutes ON period).
580 - 2,650 rpm
If you fail to observe this time limit the motor will
5
overheat. During the OFF period the motor will cool
again to its starting temperature.
B 16
Ø 1.5 - 13 mm
"The quoted values are emission values and not
13 mm
necessarily reliable workplace values. Although there
is a correlation between emission and immission
104 mm
levels it is impossible to draw any certain conclusions
50 mm
as to the need for additional precautions. Factors with
46 mm
a potential influence on the actual immission level at
the workplace include the duration of impact, the type
590 mm
of room, and other sources of noise etc., e.g. the
18 kg
number of machines and other neighboring
61.5 dB(A)
operations. Reliable workplace values may also vary
from country to country. With this information the user
74.5 dB(A)
should at least be able to make a better assessment
3 dB
of the dangers and risks involved."
3 dB
6. Before starting the equipment
230V ~ 50 Hz
6.1. Assembling the machine
Position the machine base (1).
500 W
Fasten mounting flange with pillar (2) using three
S2 15 min.
screws (3) and washers to drill base (1).
1,400 rpm
Push the drill table (4) with drill table clamp shaft
onto the pillar (2) (Fig. 4). Lock the drill table into
280 – 2,650 rpm
the desired position using the clamping screw (5).
9
Place drill head (6) with V-belt cover (7) and
B 16
motor (8) onto the drill pillar and fasten using the
Allen screws (20).
Ø 3 - 16 mm
Screw the three ball-shaped handles (9) onto the
16 mm
feeder cross handle.
115 mm
Note: All bare parts are greased in order to protect
50 mm
them from corrosion. Before mounting the drill chuck
46 mm
(10) onto the spindle (11), both parts must be
650 mm completely degreased using an environmentally
friendly solvent. This ensures optimal transmission of
21.5 kg
power.
61.5 dB(A)
74.5 dB(A)
3 dB
3 dB
Seite 11
GB
11