Use - WOLFF JIVE Traduction Du Mode D'emploi Original

1 Entriegelungsknopf
2 Schalthebel (EIN/AUS)
3 Einstellhebel für Deichselneigung
3 Dosierhebel für Reinigungsmittel
5 Halterung für Tank und Kabel
6 Netzkabel
7 Steckdose für Zusatzgeräte
1
2
3
4
01/2010

Use

Mount discs and brushes as described in Item 5.0.
After switching on the machine, the handle will move shortly to
the right.
If you feel unsafe or cannot control the machine just release
lever (4). The machine will stop at once. If you have carried out
some training, you will be able to operate the machine with one hand.
Always remove discs or brushes after work. Remove also the
cleaning tank, if one has been used. Always disconnect the
power cord after work or when leaving the machine.
Operation with vacuum cleaner
Note: the vacuum cleaner cannot -on technical grounds- remove
5
the grinding dust from under the discs. It will always remove the
fine dust. To clean the floor use a industrial cylinder vacuum cleaner.
Operation with cleaning tank
Assemble the cleaning tank with 2 supports to the handle.
6
The upper plastic mounting can be shifted by loosening the screws.
Connect the chain (1) on top of the tank with lever (2). Connect
the tube (3) of the tank with one of the 2 openings on the right
or left side of the machine. By pulling lever (2), detergent liquid
pours onto the cleaning discs or brushes. For cleaning works
with the grinding machine JIVE you need a mounting disc for
pads, pads and brushes as described in Chapter 6.
Einscheibenschleifmaschine JIVE, #056363
mount the vacuum ring from the lower side of the machine
connect the vacuum ring and the vacuum with the tubes
Put the handle (2) in working position with the big, right lever (1).
We recommend to position the hand grip in the height of
the users hip.
Lift the handle slightly, to make sure the machine stands
horizontally.
Press the safety lock (3) at the backside of the grip
Switch on the machine with the respective lever (4).
The direction in which the machine moves, is controlled by
lifting or lowering the grip. The more you lift or lower the grip,
the faster the machine runs to the corresponding direction.
lifting the grip: machine runs to the right
lowering the grip: machine runs to the left.
insert lower connector into the plastic mounting
lock the upper connector by shifting the upper plastic mounting
down
14