Publicité
Les langues disponibles
Les langues disponibles
and the serrated fender against the wood.
_
Rotate the serrated fender against the
wood to complete a cut.
The way of sawing depends on the way the
block is being supported.
Full-length support (the block is on the
ground):
_
Make a vertical cut downwards.
_
Make sure that you do not touch the ground.
Support at both ends (the block is on the
saw horse):
_
Make a vertical cut downwards to one
third of the longitudinal section.
_
Rotate the block and lay it on the saw
horse with the cut pointing downwards.
_
Make a second cut towards the first cut.
Support at one end (the block is on the saw
horse):
_
Make a vertical cut downwards.
Sawing trees
_
Make a horizontal cut to one third of the
diameter of the trunk. Subsequently make
a diagonal cut at a 45° angle from top to
bottom so that a notch is created.
_
Make a cut on the other side, but make
sure that you do not saw through the notch.
_
Place a wedge in the cut to make an
opening and drop the tree.
Felling trees is dangerous and
requires practice. If you are a
beginner or inexperienced, do not
try to teach yourself but seek
professional training.
CLEANING AND MAINTENANCE
Always pull the plug out of the
power socket before doing any
work on the chainsaw!
Keep the cooling vents on the motor housing
clean and unobstructed at all times.
Only the maintenance work described in these
operating instructions may be carried out. Any other
maintenance work must be carried out by our
Customer Service.
Do not modify the power saw in any way as this
could jeopardize its safety.
Should the chainsaw fail despite our careful
manufacturing and inspection procedures, have it
repaired by an authorized Customer Service work-
shop.
TECHNICAL DATA
Mains voltage V
Mains frequency Hz
Power input W
Speed Min-1
No load speed min-1
Bar length
cutting length
Chain brake time ms
Oil container capacity ml
Weight kg
Acoustic pressure level
LpA 94 dB(A)
Acoustic power level
LwA 107.5 dB(A) K = 3 dB(A)
Garantee : LwA 111 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard.
front handle: 3.769 m / s ²
Rear handle: 5.522m / s ²
K = 1.5 m / s ².
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
38
230
50
1800W
7600
13.5 m/sec
420mm
355mm
< 0.15 sec
120 ml
4.4kg
K = 3 dB(A)
ATTENTION !
must be worn.
Publicité
