Publicité
Les langues disponibles
Les langues disponibles
Lwa
Information of the acoustic
power level LWA in dB.
111dB
Class. II -Double insulated
Danger! Beware of kickback!
Do not cut with the tip of the guide.
The saw must be tenueà both hands
during work! If non-injury!
WARNING: Packaging materials
are not toys! Children must not
play with plastic bags! Danger of
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
This model is intended for infrequent use by
homeowners, cottagers, and campers, and for
such general applications as clearing, pruning,
cutting firewood, etc. They are not intended for
prolonged use.
It is not designed for commercial use.
1. Rear grip
2. Front grip
3. Front finger guard / Chain break
4. Saw chain
5. clamping screw for the saw chain
6. Guide bar cover
7. Guide bar
8. Rear finger guard
suffocation!
9. Power cable
10. Claw stop
11. Safety lock- button
12. Cable hook
13. ON/OFF switch
14. Oil tank cap
15. Oil gauge
16. Chain wheel
MOUNTING THE CHAIN
Important: The front finger guard (3) must
always be in the top (vertical) position.
The guide bar and saw chain are supplied
separately.
•
Place the machine on a stable
underground.
•
Loosen the nut and remove it.
•
Remove the chain guard .
•
Place the chain over the bar,
•
with the teeth pointing in the direction of
•
rotation. See the arrow on the housing.
•
Tighten the chain so that a loop is created
•
at the back of the bar.
•
Place the bar with the chain on the
•
machine. Mount the chain over the driving
wheel .
•
Place the slot in the bar over thenotch and
the screw thread .
•
Make sure that the notch of the tightening
screw falls into the hole
•
Check if the chain is properly fitted around
the bar.
•
Tension the chain. Do not over-tighten the
chain.
•
Replace the chain guard.
•
Replace the nut and tighten it securely.
Before assembling the guide bar with the saw chain,
check the cutting direction of the teeth!
TENSIONING THE SAW CHAIN
35
If the chain saw is already
connected to the power
supply: Pull the plug
from the socket outlet. Wear
protective gloves whenever
doing any work on
the saw chain.
To prevent injury on the
sharp cutting edges, always
wear gloves when
assembling, tensioning and
checking the chain.
Publicité
